<img src="the hobby shed.jpg" alt="the hobby shed picture">
The Hobbyshed.co.uk

Low Power Distribution Boards

The CN166 Low Power Distribution Boards.

The CN166 basic unit has 14 No Positive and Negative Terminals (Especially for those who don’t like to solder). The input power can be connected either by wires, a 2.1mm DC plug or a 2.5mm DC plug, the input terminal will handle up to 15 Amps, the board can be used for DC voltages up to 24vDC & DCC. (The board can be used with higher voltages, however the resister should be removed to disable the LED)

The LED will show Green if the Polarity is correct, Red if the Polarity is reversed by mistake or Orange if the Input is DCC.
Write on patch for board Voltage and Board No. There are 6 Fixing holes available
Length: 106mm
Width; 40mm
Height: 12mm

The CN166 Dimensions
An Example of wiring
The next drawing shows how the unit can be powered from three types of supply.

1 Conventional wires from an auxiliary power source,
2 A Power pack with a 2.1mm plug
3 A Power pack with a 2.5mm plug.

The outputs are Positive & negative for each 2 way terminal block of which there are 14 individual outputs.
These are ideal for powering Street Lights, House Lights, Building Lights, and so on.
The board will accept any DC voltage

On the PDF print there is a Terminal Board record as below

PDF Print